FAQs
- Security Systems > Camera > NW Camera ( operation ) > Do i-PRO cameras support both TypeA and TypeB for PoE power sourcing equipment?
Do i-PRO cameras support both TypeA and TypeB for PoE power sourcing equipment?
- Category :
Answer
i-PRO cameras except as follow, support both Type A and Type B for PoE power sourcing equipment
and conform to IEEE802.3af or IEEE802.3at (only for PTZ models) standards.
[Non-supported models]
WV-SBV111M、WV-SBV111M and the models that M connecter is used
*The models above support only Type A for PoE power sourcing equipment.
*Type A: A method of sharing data lines of 100BASE-TX (Pin 1, Pin 2, Pin 3 and Pin 6)
with power supply lines
*Type B: A method of using empty data lines of 100BASE-TX (Pin 4, Pin 5, Pin 7 and Pin 8)
as power supply lines
Was this FAQ helpful to you?
Related FAQ
- Are i-PRO cameras able to use Passive PoE power sourcing equipment?
- Do i-PRO outdoor PTZ cameras support LLDP method of PoE+ power sourcing equipment?
- What is the maximum capacity of SD memory card which can be used in i-PRO cameras?
- How much is the bit rate for audio data in i-PRO cameras?
- Are there any differences of heater performance in AeroPTZ camera, WV-SUD638, depending on power source, such as commercial power and Tested PoE injector (60 W)?
